Selecting Host Tools

Normally the installation process will supply the information required for the eCosConfiguration Tool to locate the host tools (cat, ls, etc.) necessary to perform a build. However if this information is not registered, or it is necessary to specify the location manually (for example, when a new toolchain installation has been made), select Tools->Paths->Host Tools.... The following dialog box will be displayed:

Figure 17-2. Host tools

Note: If the host tools are set here, they will take precedence over the host tools specified by the profile or PATH environment. This setting will also remain persistent across all profiles and on subsequent invocations of the Configuration Tool.

2017-02-09
Documentation license for this page: Open Publication License