Chapter 197. OpenBSD TCP/IP stack port

Note: The OpenBSD TCP/IP Stack port for eCos is deprecated and is no longer supported.

This document describes how to get started with the OpenBSD TCP/IP network stack.

Targets

A number of ethernet devices may be supported. The default configuration supports two instances of the interface by default, and you will need to write your own driver instantiation code, and supplemental startup and initialization code, if you should add additional ones.

The target for your board will normally be supplied with an ethernet driver, in which case including the network stack and generic ethernet driver package to your build will automatically enable usage of the ethernet device driver. If your target is not supplied with an ethernet driver, you will need to use loopback (see the Section called Loopback tests in Chapter 136).

2017-02-09
Documentation license for this page: Open Publication License