14.2 Overlay Commands

To use gdb's overlay support, each overlay in your program must correspond to a separate section of the executable file. The section's virtual memory address and load memory address must be the overlay's mapped and load addresses. Identifying overlays with sections allows gdb to determine the appropriate address of a function or variable, depending on whether the overlay is mapped or not.

gdb's overlay commands all start with the word overlay; you can abbreviate this as ov or ovly. The commands are:

overlay off
Disable gdb's overlay support. When overlay support is disabled, gdb assumes that all functions and variables are always present at their mapped addresses. By default, gdb's overlay support is disabled.
overlay manual
Enable manual overlay debugging. In this mode, gdb relies on you to tell it which overlays are mapped, and which are not, using the overlay map-overlay and overlay unmap-overlay commands described below.
overlay map-overlay overlay
overlay map overlay
Tell gdb that overlay is now mapped; overlay must be the name of the object file section containing the overlay. When an overlay is mapped, gdb assumes it can find the overlay's functions and variables at their mapped addresses. gdb assumes that any other overlays whose mapped ranges overlap that of overlay are now unmapped.
overlay unmap-overlay overlay
overlay unmap overlay
Tell gdb that overlay is no longer mapped; overlay must be the name of the object file section containing the overlay. When an overlay is unmapped, gdb assumes it can find the overlay's functions and variables at their load addresses.
overlay auto
Enable automatic overlay debugging. In this mode, gdb consults a data structure the overlay manager maintains in the inferior to see which overlays are mapped. For details, see Automatic Overlay Debugging.
overlay load-target
overlay load
Re-read the overlay table from the inferior. Normally, gdb re-reads the table gdb automatically each time the inferior stops, so this command should only be necessary if you have changed the overlay mapping yourself using gdb. This command is only useful when using automatic overlay debugging.
overlay list-overlays
overlay list
Display a list of the overlays currently mapped, along with their mapped addresses, load addresses, and sizes.

Normally, when gdb prints a code address, it includes the name of the function the address falls in:

     (gdb) print main
     $3 = {int ()} 0x11a0 <main>

When overlay debugging is enabled, gdb recognizes code in unmapped overlays, and prints the names of unmapped functions with asterisks around them. For example, if foo is a function in an unmapped overlay, gdb prints it this way:

     (gdb) overlay list
     No sections are mapped.
     (gdb) print foo
     $5 = {int (int)} 0x100000 <*foo*>

When foo's overlay is mapped, gdb prints the function's name normally:

     (gdb) overlay list
     Section .ov.foo.text, loaded at 0x100000 - 0x100034,
             mapped at 0x1016 - 0x104a
     (gdb) print foo
     $6 = {int (int)} 0x1016 <foo>

When overlay debugging is enabled, gdb can find the correct address for functions and variables in an overlay, whether or not the overlay is mapped. This allows most gdb commands, like break and disassemble, to work normally, even on unmapped code. However, gdb's breakpoint support has some limitations: