5.39 Controlling Names Used in Assembler Code
int foo asm ("myfoo") = 2;
This specifies that the name to be used for the variable
the assembler code should be myfoo rather than the usual
On systems where an underscore is normally prepended to the name of a C function or variable, this feature allows you to define names for the linker that do not start with an underscore.
It does not make sense to use this feature with a non-static local variable since such variables do not have assembler names. If you are trying to put the variable in a particular register, see Explicit Reg Vars. GCC presently accepts such code with a warning, but will probably be changed to issue an error, rather than a warning, in the future.
You cannot use
asm in this way in a function definition; but
you can get the same effect by writing a declaration for the function
before its definition and putting
asm there, like this:
extern func () asm ("FUNC"); func (x, y) int x, y; /* ... */
It is up to you to make sure that the assembler names you choose do not conflict with any other assembler symbols. Also, you must not use a register name; that would produce completely invalid assembler code. GCC does not as yet have the ability to store static variables in registers. Perhaps that will be added.