All blocks of flash memory (except for the boot
blocks) will be erased as part of the initialization
procedure.
Description
This command is used to initialize the Flash Image System
(FIS). It should normally only be executed once, when RedBoot
is first installed on the hardware. If the reserved images or
their sizes in the FIS change, due to a different configuration
of RedBoot being used, it may be necessary to issue the command
again though.
Note: Subsequent executions will cause loss of
previously stored information in the FIS.
Examples
Initialize the FIS directory.
RedBoot> fis init
About to initialize [format] flash image system - continue (y/n)? y
*** Initialize FLASH Image System
Warning: device contents not erased, some blocks may not be usable
... Erase from 0x00070000-0x00080000: .
... Program from 0x0606f000-0x0607f000 at 0x00070000: .
Initialize the FIS directory and all of flash memory, except for first
blocks of the flash where the boot monitor resides.
RedBoot> fis init -f
About to initialize [format] flash image system - continue (y/n)? y
*** Initialize FLASH Image System
... Erase from 0x00020000-0x00070000: .....
... Erase from 0x00080000-0x00080000:
... Erase from 0x00070000-0x00080000: .
... Program from 0x0606f000-0x0607f000 at 0x00070000: .
